Powr-Flite PF54 Manuel d'utilisation et d'entretien Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
When using electrical equipment basic safety precautions should be fol-
lowed including the following:
You must have training in the operation of this machine before using it.
Read all instructions carefully before use.
Keep children and unauthorized persons away from the machine
when in use.
Do not leave the machine plugged in when not in use.
Switch the machine off before removing the plug from the outlet.
When unplugging, pull the plug, not the cord.
The machine must be unplugged prior to cleaning or servicing
the machine .
Keep the power cord clear of moving parts.
Do not run the machine over the power cord.
Do not operate the machine with a damaged power cord or plug,
or if the machine malfunctions or is damaged in any way.
Do not use where hazardous dust is present.
Do not use in an explosive atmosphere.
Do not use where flammable liquids or gasses are present.
Do not use or pick up flammable chemicals or liquids with
this machine.
Take care when using the machine near the top of stairs to avoid
overbalancing.
Maintenance and repair must be done by authorized personnel only.
Wear suitable footwear to avoid slipping.
Do not operate this machine in bare feet or with open-toed shoes
or sandals.
Do not smoke when using the machine.
CAUTION:-This machine is for indoor use only and should not be
used or stored outdoors or in wet conditions.
The wet/dry vacuums are equipped with bypass motors. Install the cloth
filter, place the motor head on the canister and snap down the hold-down
clamps.
The wet/dry vacuums are equipped with a bypass motor so that the work-
ing vacuum is separated from the cooling air flow. To pick up water, the
dry filters must be removed. The safety float assembly, located in the vac-
uum head, stops the vacuum motor when water in the tank exceeds the
safety level.
To assemble the two piece wand:
1. Match the alignment ridges of the upper and lower wand sections.
2. Push the upper wand into the lower wand.
To assemble tools:
1. Slide the swivel cuff of the tool onto the tapered lower wand.
2. Turn swivel cuff 1/4 turn to tighten.
WAND AND ATTACHMENT INSTRUCTIONS
WET OPERATION OF VACUUM
D
RY OPERATION OF VACUUM
IMPORTANT SAFETY ADVICE
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
*When using a wet/dry vacuum, basic precautions should be followed.
*Read all instructions before using your vacuum.
Vue de la page 1
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire